Finding and fixing small water leaks
Small leaks are easy to ignore because they are quiet. The EPA's WaterSense program estimates that the average household's leaks account for more than 9,300 gallons of water wasted every year, and that nine percent of homes have leaks wasting 50 gallons or more a day.[1] A leak also wets things that should stay dry, which is how mold starts. Most leaks can be found with three simple tests.
Test 1: the water meter
This test tells you whether there is a leak anywhere in the house, even one you cannot see.
- Pick a two-hour stretch when nobody will use any water: no taps, no toilet, no dishwasher, no washing machine, no ice maker filling.
- Read the water meter at the start and write the number down.
- Read it again at the end. If it has changed at all, you probably have a leak.[1]
Your bill is another clue. WaterSense suggests looking at water use in a cold month such as January or February: if a family of four uses more than 12,000 gallons a month, there could be a serious leak.[1]
Test 2: the toilet
Toilets are the most common silent leak. Put a few drops of food coloring in the tank (the back part, under the lid) and wait 10 minutes without flushing. If any color shows up in the bowl, the toilet is leaking.[1]Flush afterwards so the coloring does not stain.
The usual culprit is the flapper, the rubber seal at the bottom of the tank. An old or worn flapper can let the toilet run or leak thousands of gallons a year, and replacing it is a quick fix.[1] To do it:
- Turn off the water at the valve behind the toilet and flush to empty the tank.
- Unhook the old flapper from the chain and the two pegs on the overflow tube.
- Take it to the hardware store to match the size, or note the brand and model printed inside the tank.
- Fit the new one, hook the chain with a little slack, turn the water back on and repeat the color test.
Test 3: a walk-around with a flashlight
Once a season, look and feel in the places leaks hide:
- Under every sink. Run the tap, then feel the pipes and the floor of the cabinet. Swelling or stains on the cabinet floor mean an old leak, even if it is dry today.
- Taps and shower heads. A tap that drips after it is turned firmly off usually needs a new washer or cartridge. A shower head that drips at the connection may only need fresh thread-seal tape.
- The water heater. Look for water or rust at the base. Leave the tank's relief valve and any gas connection to a plumber.
- Behind the washing machine. Check the hoses for bulges and cracks.
- Outside taps and the garden hose. A drip at the hose connection is often just a worn hose washer.
- Ceilings below bathrooms. A brown ring or a soft patch is worth investigating straight away.
When you find water where it should not be
Stop the source first, then dry everything. The EPA says that if wet or damp materials are dried within 24 to 48 hours of a leak or spill, in most cases mold will not grow.[2] Use fans, open windows when the air outside is dry, and pull back anything soaked. If drywall, insulation or carpet stays wet, it may need to come out; the damp and mold guide explains why.
When it is a plumber's job
- A meter test that shows a leak you cannot find.
- Any leak inside a wall, under a floor or in the ceiling.
- Anything involving the water heater's controls or relief valve, or a gas line.
- A main shut-off valve that will not turn.
Before anything else, find your main shut-off valve and make sure everyone in the house knows where it is.
Sources
Each source was checked on 2026-11-18. Advice changes; the agency's own page is the one to rely on.